Swing Gate Opener

Yes. You can cancel the human sensor opening mode via the remote control. Operation steps: After the door is fully closed, long-press the Close button on the remote for 5 seconds to deactivate the human body sensor opening function. To re-enable it: When the door is fully open, long-press the Open button on the remote for 5 seconds to restore the normal human body sensor opening function.

Enter the swing gate opener controller menu P-00 to adjust the opening speed, and menu P-01 to adjust the closing speed. The higher the value, the faster the speed; the lower the value, the slower the speed.

Enter the swing gate opener controller menu P-23. The value ranges from 0 to 1.

0： stands for left-hand opening, and 1 for reverse direction.

Enter the controller Menu P-13; the display will show the number of currently stored remote controls.
In this menu, press the “+” or “-” key to adjust the value of learned remotes. Press the Menu key to confirm. All learned remotes corresponding to entries after this value will be deleted.

Three reset modes. Enter controller menu P-27. To prevent misoperation, set a specific value and then press the Menu key to execute the operation.

5: Clear all remotes

10: Partial factory reset (remotes and motor type remain unchanged)

15: Full factory reset

Enter controller menu P-33 to set the auto-test time interval. When set to 0, the auto-test function is disabled. This function is used for automatic testing and burn-in testing. After testing, set this parameter to 0 to exit auto-test mode. Short-press the Open button to start.

Enter controller menu P-14. If set to 0, auto-close function is disabled.
Unit: 1 second, adjustment range: 0–255 seconds.
After setting, the door will automatically close after staying open for the configured time.

After the swing gate fully open positon, press and hold the【STOP】 button on the remote controller for 5 seconds to enable the hold-open mode. Press the 【CLOSE】 button to cancel this function.

Enter the controller menu P-13, the screen will display the number of currently saved remote controls. Press the Open, Close and Stop buttons on the remote in sequence to perform learning.

Note: Keep pressing a button until the control board beeps once, then release it. Proceed to the next button. The learning for this remote is completed when the control board emits a long beep or the number on the digital tube increments. You may continue to learn another remote, or press Cancel to exit.