Support
Support
-
How to reset the swing gate opener controller setting？
Three reset modes. Enter controller menu P-27. To prevent misoperation, set a specific value and then press the Menu key to execute the operation. 5: Clear all remotes 10: Partial factory reset (remotes and motor type remain unchanged) 15: Full factory reset
Read more → -
How to delete Remote Controllers for Swing Gate Opener？
Enter the controller Menu P-13; the display will show the number of currently stored remote controls.In this menu, press the "+" or "-" key to adjust the value of learned remotes. Press the Menu key to confirm. All learned remotes corresponding to entries after this value will be deleted.
Read more → -
Swing gate opener add the remote controller method？
Enter the controller menu P-13, the screen will display the number of currently saved remote controls. Press the Open, Close and Stop buttons on the remote in sequence to perform learning.Note: Keep pressing a button until the control board beeps once, then release it. Proceed to the next button. The learning for this remote is completed when the control board emits a long beep or the number on the digital tube increments. You may continue to learn another remote, or press Cancel to exit.
Read more → -
For swing gate opener if a human body sensor is connected, how do I temporarily disable the detection function?
Yes. You can cancel the human sensor opening mode via the remote control. Operation steps: After the door is fully closed, long-press the Close button on the remote for 5 seconds to deactivate the human body sensor opening function. To re-enable it: When the door is fully open, long-press the Open button on the remote for 5 seconds to restore the normal human body sensor opening function.
Read more → -
How to set the swing gate opener to hold-open mode
After the swing gate fully open positon, press and hold the【STOP】 button on the remote controller for 5 seconds to enable the hold-open mode. Press the 【CLOSE】 button to cancel this function.
Read more → -
Instruction-Manuals|K2-SW
This Controller Instruction-Manuals is Used For H3/H5/K5/H7/H10/H8 Swing Gate Opener.
Read more → -
Motor Mounting Base|A-SW-H3-MMB|Technical Drawing
It used for The technical drawing is provided for customers to pre-measure and reserve holes before installation.
Read more → -
E4 Fence Boom Barrier Gate Installation Project Case
This is our completed project of E4 fence boom barrier gate, installed at a wide vehicle entrance. The double-unit fence boom barrier is designed for extra-wide passageways. The…
Read more →
